Clone Stamp
Clone Stamp
Use Clone Stamp to remove defects or repeated scan artifacts by copying a clean source region into a target area. An optional brush mask can shape the copied region.
Availability
This node is available in the free feature set.
Common uses
- Pick a source point with similar texture direction and lighting.
- Use a soft brush or mask for less visible repairs.
Input ports
-
input -
brushMask -
Requires an image input. Brush Mask is optional and is sampled as grayscale influence.
Output ports
-
out -
Outputs the repaired image using the input image format.
Parameters
| Parameter | Type | Default | Range or values |
|---|---|---|---|
| Source X | float | 0.25 | 0 to 1 |
| Source Y | float | 0.5 | 0 to 1 |
| Target X | float | 0.75 | 0 to 1 |
| Target Y | float | 0.5 | 0 to 1 |
| Brush Size | float | 1 | 0.01 to 1 |
| Hardness | float | 0.75 | 0 to 1 |
| Opacity | float | 1 | 0 to 1 |
Behavior
- Copies source pixels by target-relative offset and blends them through brush falloff, opacity, and optional mask input.
Common mistakes
- Large hard brushes can create obvious repeated patches.
- Copying from mismatched texture direction can leave visible repair marks.